Kifutott termék. A kategóriába visszalépve rengeteg féle hasonló szettet találhat!
4 csatornás távirányító, 4 csatornás relés vevő védődobozban
Jelllemzők:
Wireless remote control switch is a very broad application of wireless control devices , the use of
intelligent microprocessor control , which can be used in garage door control, lighting control , remote
control curtains and other areas, with easy installation, simple to use safe and reliable.
Model : TAD-T70
Scope: garage doors, appliances switches or other areas of wireless control
Specifikáció:
1 Working voltage : 12VDC
2 Static current : ≤ 9mA
3 relay contact capacity : 10A 250VAC | 10A 30VDC
4 Load power: ≤ 40W Single
5 Operating frequency : 315MHz
6 Remote distance: no interference space max 200 m ( this distance is open to non-interference of the
theoretical distance , the use of the interference may be reduced depending on the environment . Nominal
distance is usually 10 % -50% . ) We measured 30 meters.
(tájékoztató jellegű adat, optimális körülmények között)
7 Load Type: fluorescent energy saving lamp LED light load motor ...... etc.
8 Output: relay common / normally open / normally closed
10 Control mode : the user can modify the control mode , shorting jumper cap and T is self-locking
type (T) control mode ; jumper cap and M is a short jog type (M) control mode ; T and M are two is not
less then interlocked control mode. ( Tips: switching control modes required to take off again before the
power control mode conversion )
11 Control Channels : 4
Self-locking control mode : Click the button corresponding relay switches in the same key , click the
corresponding relay is switched off , ABCD four independently -off .
Jog type control mode : Long press buttons corresponding relay switches , release the button
corresponding to the relay is switched off , 4-way can not work independently , each only way to work ;
Interlocked control mode: Press the A button A and lock has been switched on, press the B button to
disconnect A , B and lock has been switched on, press the C key to disconnect the B, C Lu has been turned
ON and locked press the D key to disconnect C, D Road has been turned on and turned the lock , you can
only turn all the way , and as fans gear . )
Tips: Remote control buttons Press only one button can not hold down two or more keys simultaneously ,
otherwise it will affect the normal work of mutual interference .
12 learning the code method : Click the button to learn , indicator lights , release the button to
learn , within 15 seconds, press any button on the remote control , the receiver learn LED flash , remote
control and receiver success of the code . after 15 seconds if no transmitter signal is input to learn,
learn about LED flash , auto- exit learning state , supports up to 30 different remote control code
learning the code , when learning to 31 remote will automatically clear the first remote control
controller .
13 Clear the right code method ; tight hold button and hold the receiver to learn , learning indicator
lights After about 8 seconds , until the learn indicator light goes out , release the learn button ,
remove all code learning remote control.
Csomagban:
- 4 CH RF Wireless Remote Control Controller védődobozzal
- 4 CH távirányító (elem szükséges hozzá, speciális alkáli 23A, rendelhető)